Skip to content
9AM - 5PM CST / Monday - Friday
(855) 906-6498
9AM - 5PM CST / Monday - Friday


IPCamPower POE Combiner Splitter Adapter,Run 2 IP Cameras on 1 Cable IPCP-212X


  • Allows you to run 1 cable run to the switch for 2 cameras that are near each other. Set consists of a "sender" unit and a "receiver" unit. Plug Sender unit into 2 open ports on your POE switch. Run one cable to the location that has the cameras that are nearby each other. Connect 2 short cables to the Receiver unit and connect the other ends to your camera. Done!
  • Reduces cabling costs. Lets say you are installing 2 cameras on each side of a corner. Instead of running 2 cables back to the switch, you can now just run 1. Easy and Cost Effective.
  • Ever installed a camera in a location, only to find out that you need another one right by it? Whats worse, the switch is on the other side of the building and it took you hours to run that one cable run. No worries! Just use this splitter set to make your installation much easier as all you need to do now is run 1 cable from the old camera to the new camera.
  • The Receiver Unit comes with weatherproof RJ45 connectors, allowing you to fully expose the Receiver unit to the weather elements.
  • Simple plug n play installation. Works with all standard 802.3af/at POE switches. Also works on POE NVRs due to the new updated design with the onboard toggle switch. If your switch or NVR uses standard POE power, this unit will work!
  • UPC: 753215818273
Simply Plug the Combiner Unit into a POE Switch or POE NVR

This works on any standard POE Switch or POE NVR. Simply plug it in with no IP configuration needed. Your switch or NVR will "think" you are using 2 cables.

This combines the 2 ports of POE and Data into 1 cable.

The special Combiner unit then takes the 2 cables from the POE switch or POE NVR and combines the data and POE power into one cable. You entire cable run between the POE Switch/NVR and Cameras should not exceed the standard 330' allowable by a standard network run.

Then at the camera end, the splitter will split out the POE and Data into 2 shorter cables.

The splitter unit will be installed near your cameras and it takes the combined POE power and Data and splits it back out to 2 cables again.

The finished product is simple and effective.

The finished product is a simple yet effective solution that will save you time and money in your next IP Camera installation.

Free Shipping to the USA